Description

Simpson Strong-Tie DSP Package of 10 The Stud Plate Tie series offers various solutions for connecting the stud to the top and bottom plates. All models can be used to make a connection to either the top or bottom plate, and several are suitable for double top plates and studs. Material: DSP/SSP/SPH—18 gauge, TSP—16 gauge; all others—20 gauge Finish: Galvanized. Some products available in ZMAX® coating ; see Corrosion Information . Installation: Use all specified fasteners; see General Notes . TSP/DSP/SSP - sill plate installation - fill all round holes. TSP/DSP/SSP - top plate installation - fill all round and triangle holes SP1/SP2/SP3/SP5 - one of the 10d common stud nails is driven at a 45° angle through the stud into the plate. Allowable loads have been increased 60% for wind or earthquake loading; no further increase allowed. When cross-grain bending or cross-grain tension cannot be avoided, mechanical reinforcement to resist such forces should be considered. Allowable loads for DSP installed to a rim joist are 660 lbs. (DF/SP), 545 lbs. (SPF/HF). Noted values only apply to DF/SP members. For SPF values, multiply by 0.86. Southern pine allowable uplift load is 585 lbs. NAILS: 10d = 0.148" dia. x 3" long, 10dx1 1/2 = 0.148" dia. x 1 1/2" long. See other nail sizes and information . We stock a full line of Simpson Strong-Tie products so if you need something special just ask and we will make a listing for you!! On Mar-14-13 at 15:49:15 PDT, seller added the following information: Every buyer gets a MyStoreRewards invitation for cash back Your browser does not support JavaScript. To view this page, enable JavaScript if it is disabled or upgrade your browser.